Some Steps for Netgear Extender Setup via WPS button
Another way to perform the Netgear Extender Setup is via Wi-Fi protected setup or WPS button. Hence, this section includes the instructions to finish the setup of the Netgear extender. Therefore, the users are suggested to travel through the subsequent points for an equivalent.
- Firstly, the users are advised to show the Wi-Fi extender “ON” by plugging it into the facility socket.
- After that, the users are suggested to look the WPS button on their device.
- Next, the users should long-press the WPS button for a couple of seconds.
- After this, the users are recommended to attend till the LED light turns solid green.
- Note: The users who have a dual-band wireless range extender are suggested to repeat an equivalent process.
- Lastly, the users are recommended to attach the router with the Netgear extender’s network and are advised to use an equivalent password as that of the router.
After following the above guidelines, the users can efficiently perform the Netgear Extender Setup. Once the steps are finished properly, the users can connect their devices with the Netgear extender network and avail of a high-speed internet connection.
Aw, this was a very nice post. Taking a few minutes and actual effort to make
ReplyDeletea very good article… but what can I say… I put things off a whole lot and don’t manage to get nearly anything done. A very cool post, i actually love this web site, carry on it stays on topic and states valid points. Thank you.
토토